Buck Converter Not Increasing the Current?

The output current needs to be supplied by the input power supply, in bursts. It's only the average input current that's supposed to be 1.66A, the actual current will cycle between none, and about 4A. If the input power supply has overcurrent protection, it may shut down on these peaks, messing with your converter. You need an input capacitor across the power supply, which can source these short term current peaks

1. Creative Zen Video Converter Problem?

Try a different converter like SUPER (erightsoft.com) or reinstall your Zen software

2. good free video converter?

Use Format Factory It's A fastest video converter O It is convert All media format and you customize you output format. Its Free

3. mechanic messed up my car?

I do not see the need for a flywheel or converter unless you did real damage to them but unlikely. As for the park , reverse, etc sounds like they just backed off the cable adjustment on your shifter linkage and will readjust it back which will take 3 minute but they will charge you for a park they never put on. Always ask for the part and have them show you the part that needs to be replaced even if you do not know what you are looking at. They will assume you are going to double check there work and they will not try and take an advantage of you. Sorry but I think you have been taken for a ride. Do not recommend going back. Chalk it up as lesson learned not much recourse on this one. You can try to get him to pay for the repairs but you will need to get it repaired first and show him the bill to prove he screwed up your car. Good luck.

4. HDMI to component converter help?

Try this: Take your MP3 player and sing into the ear-buds. Does the MP3 player record your song? Of course not. Digital to analog is 1 direction. Analog to digital is 1 direction. These are not 'simple' cables.

5. catalytic converter bad 08 forenza?

Your emission system has a federal warranty for 100,000 miles as per the U.S. government and the DOT. Go on-line and go to the DOT web-site for emissions warrantys, print the law, then take it to the dealer. If they refuse there is a telephone number on the page and I KNOW for a fact once the feds get wind of the dealers game, that dealer will be happy to change it for you.

6. What is the best free video converter?

You could try Video Converter Ultimate. They cost money though, but you can download and try it out

7. Can I use a USB-FTDI TTL converter cable as a USB-TTL converter cable?

I have the need of a USB-TTL converter cable, but all I have is a USB-FTDI converter cableFTDI is just the brand of the manufacturer, both cables that you shown do the same thing.What you describe as USB-FTDI is a USB-TTL converterThe USB TTL Serial cables are a range of USB to serial converter cables which provide connectivity between USB and serial UART interfaces. A range of cables are available offering connectivity at 5V, 3. 3V or user specified signal levels with various connector interfaces.All cables feature an FTDI FT232R device integrated within the cable USB type 'A' connector, which provide access to UART Transmit (Tx), Receive (Rx), RTS#, CTS#, VCC (5V) and GND connections. All cables are fully RoHS compliant and are FCC/CE approved. The use of RTS (Request to Send) and CTS (Clear to Send) handshaking depends on the specific implementation and the way you will use the cable in your project

8. selection of transformer for flyback converter

The PA3856.006NL can be used as a flyback transformer. Note 2 in the data sheet states this: -Given that the peak primary current is calculated as 10 amps on the lowest input volts, Bpk (Gauss) = 41.7 x 10 = 417 gauss and this is well short of 2700 gauss. Your approach does seem correct but you forgot to mention operating frequency however, i reasoned that the on time is 4.72 us if that helps.The turns ratio is 0.47:1 as shown by the little numbers on the picture of the transformer in your question.Dual output means you can wire them in series or in parallel. Saturation of the core is caused by primary current reaching too high a value